CADint.com
http://www.cadint.com/support-forum/

symbol not appearing when creating new part ref
http://www.cadint.com/support-forum/viewtopic.php?f=4&t=107
Page 1 of 1

Author:  gregm [ Mon Oct 27, 2014 11:28 am ]
Post subject:  symbol not appearing when creating new part ref

Hi,

I'm new to CADint, but been using it for a week or so. I've created new sch. symbols, pcb symbols and partrefs, but now when trying to do a new partref for a connector I add my gate (sch. symbol) but it doesn't show. All I get is a yellow rectangle. What am I doing wrong?

Page 1 of 1 All times are UTC - 8 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/